Skip to content
Tutorials Center
My learning

Topics

Lesson 10 of 45 ยท From Schematic to Board

Chapter 2 Review: From Schematic to Board

Review schematic capture, netlists, ERC, BOM and board setup with a recap table, a one-picture summary and a ten-question quiz for chapter 2.

This chapter followed one idea: the schematic says what connects, the board says where. You learned to capture a circuit, to read what it produces and to set up a board so that the factory can build it. The picture below shows the five steps in order.

A dotted wavy path with five numbered circles: capture, ERC, footprints, rules and update PCB, showing the order from schematic to board
Chapter 2 in one picture: five steps from schematic to board.

Recap table

Topic Key points
Schematic capture Symbols, unique reference designators (R, C, D, U, J), values, junction dots, labels, power symbols
LED resistor R = (Vsupply โˆ’ Vf) / I, round to E12, check power
Netlist Nets as groups of pins; the input to layout
ERC Catches rule violations; cannot catch wrong values or pinouts
BOM One line per part type, with quantity, footprint and MPN
Board setup Outline, mounting holes, layers, stack-up from the fab
Design rules 0.2 mm trace and clearance, 0.3/0.6 mm via, ring โ‰ฅ 0.15 mm
DRC Checks geometry against your rules

Lessons in this chapter

Check your understanding

Quick check ยท 10 questions

of 10 answered You scored / 10 ยท perfect!

  1. 1. Which letter prefix is used for a capacitor?

    C is the standard reference designator prefix for capacitors.
  2. 2. Two schematic wires cross without a junction dot. What does that mean?

    Only a junction dot makes a connection.
  3. 3. A 9 V supply, a green LED with Vf = 2.2 V at 10 mA. Which resistor is closest to the calculated value from the E12 series?

    (9 โˆ’ 2.2) / 0.010 = 680 ฮฉ, which is an E12 value.
  4. 4. What is a netlist?

    It describes connectivity.
  5. 5. Which error will ERC NOT find?

    Value correctness is a design question that needs human review.
  6. 6. In the BOM, three identical 10k 0603 resistors appear as

    Identical parts are grouped.
  7. 7. Where should you change a component value?

    The schematic is the single source of truth.
  8. 8. A via with a 0.5 mm pad and 0.3 mm drill has what annular ring?

    (0.5 โˆ’ 0.3) / 2 = 0.1 mm, below a typical 0.15 mm minimum.
  9. 9. Why set design rules before routing?

    Late rules mean rerouting and mistakes.
  10. 10. A clean DRC means

    DRC is only a geometry check.

Summary

  • Schematic, netlist and board describe one circuit in three forms.
  • ERC and DRC are useful but limited; careful review fills the gaps.
  • Set the outline, stack-up and rules from your fab before the first trace.

Next: Chapter 3 Overview: Components and Footprints