Skip to content
Tutorials Center
My learning

Topics

Lesson 17 of 37 ยท Energy Sources

Nuclear Power

How nuclear fission produces electricity, how reactors work, the issues of waste, safety and cost, and a calculation of the energy in a kilogram of uranium.

Nuclear power plants produce about 9-10 % of the world's electricity (the share has fallen slowly from a peak in the 1990s), and they do it with almost no carbon dioxide emissions while running. Yet nuclear energy is also one of the most debated energy sources, because of accidents, long-lived waste and weapons concerns. This lesson explains how it works and presents the arguments on each side.

Fission in brief

Atoms have a nucleus made of protons and neutrons. Nuclear fission is the splitting of a heavy nucleus into two lighter ones. In a reactor, a slow-moving neutron hits a nucleus of uranium-235, which splits, releasing:

  • a large amount of energy, about 200 MeV (million electron volts) per fission, mostly as the kinetic energy of fragments that turns into heat;
  • two or three more neutrons.

If at least one of those neutrons causes another fission, a chain reaction is sustained. The energy comes from a tiny loss of mass: the products weigh slightly less than the original nucleus, and Einstein's relation E = mcยฒ converts that mass difference into energy.

Natural uranium is mostly uranium-238 (about 99.3 %), with only about 0.7 % uranium-235. Most reactors need fuel enriched to roughly 3-5 % uranium-235. Weapons-grade material is enriched far higher (about 90 %), which is why enrichment is closely monitored internationally.

flowchart LR
    A["Fission of U-235<br/>releases heat and neutrons"] --> B["Water is heated<br/>to steam"]
    B --> C["Steam spins a turbine"]
    C --> D["Generator makes<br/>electricity"]
    B --> E["Condenser and<br/>cooling system"]

A nuclear plant is a steam power plant with nuclear fission as the heat source.

Inside a reactor

A typical reactor contains:

  • Fuel rods: ceramic pellets of uranium oxide in metal tubes.
  • A moderator (often ordinary water, heavy water or graphite) that slows neutrons so they are more likely to cause fission.
  • Control rods (made of neutron-absorbing material such as boron or cadmium) that can be pushed in to absorb neutrons and slow or stop the reaction.
  • A coolant that carries away heat (water in most reactors).
  • A containment structure of thick steel and concrete.

The most common type is the light-water reactor (pressurized water reactor, PWR, or boiling water reactor, BWR). A reactor cannot explode like a nuclear bomb, because the fuel is not enriched enough and is not arranged that way. The main danger is overheating: even after shutdown, radioactive decay keeps producing heat (decay heat), so cooling must continue.

The energy in uranium

The next program calculates how much energy is released if every U-235 atom in one kilogram fissions completely. Real fuel is only partly burned and contains mostly U-238, so this is an upper limit used to show the scale.

Python Energy in 1 kg of uranium-235

Press Run (or Ctrl + Enter) to see the result here.

Program input ยท what you'd type while the program runs

Type the answers before you press Run, one per line. Each time the program reads a line (with input()), it gets the next line from this box.

The result is millions of times more energy per kilogram than coal. This high energy density is a major advantage of nuclear power: a plant needs small amounts of fuel and creates a small volume of waste.

Advantages

  • Very low greenhouse gas emissions when operating; lifecycle assessments (mining, construction, waste) give values comparable with wind and well below fossil fuels.
  • Reliable, around-the-clock output. Nuclear plants often run at a capacity factor above 90 %: the share of the maximum possible output that is actually produced over a year.
  • High energy density and a small land area.
  • Low air pollution compared with coal.

Challenges

  • Radioactive waste. Used fuel is highly radioactive, and some of it stays dangerous for tens of thousands of years or more. Currently most waste is stored in cooling pools and then in dry casks at plant sites. A deep geological repository is the favored long-term solution: Finland's Onkalo repository is the first to be built for spent fuel on a commercial scale. The amount is small: all the used fuel from one reactor in a year would fit in a modest storage space.
  • Accidents. Three major accidents shape public opinion: Three Mile Island in the United States (1979, a partial meltdown with little release to the public), Chernobyl in Ukraine (1986, a reactor explosion and fire that spread radioactivity widely and caused the evacuation of large areas), and Fukushima Daiichi in Japan (2011, when an earthquake and tsunami disabled cooling and three reactors melted down). Statistically, nuclear power has had a low death toll per unit of energy compared with coal, oil and gas, once air pollution is included, but accidents can have severe local and social effects such as evacuations.
  • Cost and construction time. New plants in many countries have been expensive and have run over budget and schedule.
  • Weapons proliferation. Some enrichment and reprocessing technology can be used to make weapons, so international inspection is needed.
  • Mining and decommissioning. Uranium mining has environmental impacts, and old plants must be dismantled at considerable cost.
  • Water use and heat. Plants need cooling water, which can raise river temperatures.

Different studies weigh risks differently. A fair assessment compares nuclear power with the real alternatives (for example, coal), not with a perfect energy source.

Fusion and new designs

Nuclear fusion joins light nuclei (hydrogen isotopes) into heavier ones, as in the Sun. It would produce little long-lived waste and uses abundant fuel, but sustaining the extremely hot plasma has proved very hard, and commercial fusion power is not yet available. Small modular reactors (SMRs) are designed to be built in factories and installed in modules, aiming to lower cost and improve safety. Their commercial performance is still being proven.

A capacity factor calculation

A plant's annual energy is rated power ร— hours in a year ร— capacity factor. The next program compares an example nuclear plant with a solar farm of the same rated power. Capacity factors vary by site and technology, so the values are typical examples.

Python Annual output and capacity factor

Press Run (or Ctrl + Enter) to see the result here.

Program input ยท what you'd type while the program runs

Type the answers before you press Run, one per line. Each time the program reads a line (with input()), it gets the next line from this box.

A nuclear reactor of 1,000 MW can produce several times more energy over a year than a solar farm of the same rated size. This does not make one "better": cost, siting and flexibility also matter.

Check your understanding

Quick check ยท 4 questions

of 4 answered You scored / 4 ยท perfect!

  1. 1. What is the role of control rods in a nuclear reactor?

    Control rods contain neutron absorbers; moving them in or out changes how many neutrons are available to cause fission.
  2. 2. Which isotope is the main fissile fuel in most reactors?

    U-235 is fissile (splits easily with slow neutrons). Natural uranium is mostly U-238, so fuel is enriched to a few percent U-235.
  3. 3. What is the capacity factor of a plant that has a rated power of 500 MW and produces 3,500 GWh in a year (8,760 hours)?

    Maximum possible = 500 MW ร— 8,760 h = 4,380 GWh. 3,500 รท 4,380 โ‰ˆ 0.80.
  4. 4. Which of these is a key challenge of nuclear power?

    Used fuel stays radioactive for a very long time, so safe storage and disposal is a central challenge.

Summary

  • Fission of U-235 releases heat; the heat makes steam that drives a turbine.
  • Reactors use fuel enriched to a few percent U-235, moderators, control rods and coolant.
  • One kilogram of U-235 fully fissioned releases roughly 8 ร— 10ยนยณ J, millions of times more than a kilogram of coal.
  • Advantages: very low operating COโ‚‚, high reliability (capacity factors above 90 %), small land use.
  • Challenges: long-lived waste, rare but serious accidents, cost, proliferation.

Next: Solar and Wind Energy