Skip to content
Tutorials Center
My learning

Topics

Lesson 35 of 38 · Gas Laws

Dalton's Law and Gases Collected over Water

Learn Dalton's law of partial pressures, mole fractions in gas mixtures, air composition and how to correct for water vapor when a gas is collected over water.

Real gases usually come as mixtures: air is mostly nitrogen and oxygen, the gas in a scuba tank may be a blend, and a gas bubbled through water carries water vapor with it. How does each gas contribute to the total pressure? Dalton's law answers this, and it is the key to a classic laboratory technique: collecting a gas over water.

Dalton's law of partial pressures

In a mixture of gases that do not react, each gas behaves as if it were alone in the container. The pressure it would exert alone is its partial pressure. The total pressure is the sum:

P_total = P₁ + P₂ + P₃ + ...

Each partial pressure follows the ideal gas law with its own moles: Pᵢ = nᵢRT / V.

Dividing partial pressure by total pressure gives the mole fraction:

Pᵢ = Xᵢ × P_total where Xᵢ = nᵢ / n_total

Example: a 10.0 L flask holds 2.00 mol of N₂ and 1.00 mol of O₂ at 300 K. The total is 3.00 mol.

  • X(N₂) = 2.00 / 3.00 = 0.667, X(O₂) = 0.333.
  • P_total = nRT / V = (3.00 × 0.08206 × 300) / 10.0 = 7.39 atm.
  • P(N₂) = 0.667 × 7.39 = 4.92 atm; P(O₂) = 0.333 × 7.39 = 2.46 atm.
Python Partial pressures in a mixture

Press Run (or Ctrl + Enter) to see the result here.

Program input · what you'd type while the program runs

Type the answers before you press Run, one per line. Each time the program reads a line (with input()), it gets the next line from this box.

Composition of air

Dry air at sea level is roughly 78 % nitrogen, 21 % oxygen and about 0.9 % argon by volume (and so by moles), with small amounts of carbon dioxide and other gases (CO₂ is currently around 0.04 %). At a total pressure of 1.00 atm, the partial pressure of oxygen is about 0.21 atm. At the top of a high mountain the total pressure is much lower, so the partial pressure of oxygen is lower too, even though the oxygen fraction is the same. That is why climbers feel short of breath: what matters for breathing is the partial pressure of oxygen, not just the percentage.

Divers must also watch partial pressures. At large depths the pressure of gases breathed in increases, and a high partial pressure of oxygen or of nitrogen becomes harmful, so special gas mixtures are used.

Collecting a gas over water

A gas that does not dissolve much in water, such as hydrogen or oxygen, can be collected by bubbling it into an inverted container filled with water. As the gas enters, it pushes the water out.

flowchart LR
    R["Reaction flask<br/>makes gas"] --> T["Delivery tube"]
    T --> C["Inverted cylinder<br/>filled with water"]
    C --> M["Gas + water vapor<br/>inside"]

The collected gas is wet: it is a mixture of the product gas and water vapor.

The gas in the tube is saturated with water vapor. When the water levels inside and outside the cylinder are equal, the pressure inside equals the atmospheric pressure:

P_atm = P_gas + P_water vapor

so

P_gas = P_atm - P_water vapor

The vapor pressure of water depends only on temperature. At 25 °C it is about 23.8 mmHg (3.17 kPa); at 20 °C it is about 17.5 mmHg; at 30 °C, about 31.8 mmHg. Tables of these values are standard in chemistry data books, and the values here are approximate.

Example. Oxygen from the decomposition of potassium chlorate is collected over water at 25 °C. The barometer reads 755 mmHg, and the collected volume is 0.285 L.

  • P(O₂) = 755 - 23.8 = 731.2 mmHg = 731.2 / 760 = 0.962 atm.
  • n(O₂) = PV / RT = (0.962 × 0.285) / (0.08206 × 298.15) = 0.01121 mol.
  • Mass of O₂ = 0.01121 × 32.00 = 0.359 g.

Without the water-vapor correction you would have overestimated the oxygen.

Python Gas collected over water

Press Run (or Ctrl + Enter) to see the result here.

Program input · what you'd type while the program runs

Type the answers before you press Run, one per line. Each time the program reads a line (with input()), it gets the next line from this box.

Graham's law: a brief note on mixing and effusion

Gas mixtures also differ in how fast the components move. Graham's law says that the rate of effusion (escape through a tiny hole) of a gas is inversely proportional to the square root of its molar mass:

rate₁ / rate₂ = √(M₂ / M₁)

Light gases escape faster than heavy ones. Hydrogen (2.016 g/mol) effuses about four times faster than oxygen (32.00 g/mol), since √(32.00 / 2.016) = about 3.98.

Python Graham's law calculator

Press Run (or Ctrl + Enter) to see the result here.

Program input · what you'd type while the program runs

Type the answers before you press Run, one per line. Each time the program reads a line (with input()), it gets the next line from this box.

Common mistakes

  • Forgetting the water-vapor correction for a gas collected over water.
  • Adding mole fractions to different totals. Mole fractions of a mixture always sum to 1.
  • Using percent by mass instead of percent by moles (volume) for partial pressures.
  • Mixing pressure units, especially mmHg and atm.

Check your understanding

Quick check · 4 questions

of 4 answered You scored / 4 · perfect!

  1. 1. A container holds gases with partial pressures 0.40 atm, 0.25 atm and 0.10 atm. What is the total pressure?

    Dalton's law: P_total = 0.40 + 0.25 + 0.10 = 0.75 atm.
  2. 2. A mixture has 3.0 mol of gas A and 1.0 mol of gas B at 2.0 atm total. What is the partial pressure of A?

    X(A) = 3.0 / 4.0 = 0.75, so P(A) = 0.75 × 2.0 atm = 1.5 atm.
  3. 3. A gas is collected over water at 755 mmHg. If water vapor pressure is 24 mmHg, what is the pressure of the dry gas?

    P_gas = P_atm - P_water vapor = 755 - 24 = 731 mmHg.
  4. 4. Which gas effuses fastest at the same temperature?

    Graham's law: the lightest gas (H₂) effuses fastest.

Summary

  • Dalton's law: P_total = P₁ + P₂ + ..., and Pᵢ = Xᵢ × P_total.
  • Oxygen in air has a partial pressure of about 0.21 atm at sea level, and it falls with altitude.
  • A gas collected over water is mixed with water vapor: P_gas = P_atm - P_water vapor.
  • The vapor pressure of water depends on temperature only (about 23.8 mmHg at 25 °C).
  • Graham's law: lighter gases effuse faster, with rate proportional to 1/√M.

Next: Practice Set 1: Moles, Yield and Limiting Reagents