Skip to content
Tutorials Center
My learning

Topics

Lesson 22 of 37 · Weathering, Erosion and Soil

Soil Properties and Conservation

Learn soil texture, structure, porosity, pH and nutrients, then see how contour plowing, terracing, cover crops and no-till farming protect soil from erosion.

Two fields can look alike and yet behave very differently: one drains fast and dries out, another holds water and becomes sticky mud. The difference lies in soil properties. In this lesson you learn how to describe soil (texture, structure, porosity, pH, nutrients) and how people protect it from the erosion you met in Erosion and Deposition.

Texture

Soil texture describes the mix of mineral particle sizes. Soil scientists following the USDA system use these limits:

Particle Diameter
Sand 0.05 to 2 mm
Silt 0.002 to 0.05 mm
Clay below 0.002 mm

Sandy soils drain quickly and warm up fast but hold few nutrients. Clay soils hold water and nutrients well but drain slowly and can become waterlogged and hard. Loam, a balanced mix of sand, silt and clay, is generally best for plants. Different countries use slightly different size limits, so always check which system a book uses.

Structure and porosity

Structure is how particles clump into aggregates (crumbs, blocks, plates). Humus and roots glue them together. Good crumb structure leaves pores of many sizes for air and water.

Porosity is the fraction of the soil's volume that is pore space. It can be found from two densities:

porosity = 1 − (bulk density / particle density)

Bulk density is the dry mass of soil divided by its total volume including the pores. Particle density of most mineral soil is close to 2.65 g/cm³. Compaction (by machinery, for instance) raises the bulk density and reduces porosity, so roots and water struggle to get in.

Python Porosity from bulk density

Press Run (or Ctrl + Enter) to see the result here.

Program input · what you'd type while the program runs

Type the answers before you press Run, one per line. Each time the program reads a line (with input()), it gets the next line from this box.

Soil pH and nutrients

pH measures acidity on a scale where 7 is neutral, below 7 acidic and above 7 alkaline. Because the scale is logarithmic, a soil at pH 5 has ten times the hydrogen-ion concentration of pH 6. Most crops grow best between about pH 6 and 7.5, though some, such as blueberries, prefer acidic soil. pH affects which nutrients plants can absorb.

Plants need nitrogen, phosphorus and potassium in the largest amounts (the N-P-K on fertilizer bags), plus calcium, magnesium, sulfur and traces of iron, zinc and others. Clay and humus hold positively charged nutrient ions on their surfaces, a property called cation exchange capacity, so they act like a nutrient bank.

JS pH difference: how many times more acidic?

Press Run (or Ctrl + Enter) to see the console output here.

No output.

Why soil erodes

Bare soil on a slope is easily carried away by rain and wind. Erosion is fastest when:

  • the ground has no plant cover,
  • the slope is steep and long,
  • the soil is loose or has low organic matter,
  • rain falls in heavy bursts.

Raindrops hit bare soil like tiny bombs, breaking up crumbs. Water then runs off as sheet erosion (thin layer), rills (small channels) and finally gullies (deep channels). Because topsoil is the most fertile layer, erosion removes the most valuable soil first. Loss of topsoil can lower crop yields and also muddies rivers and lakes.

Conservation methods

Method How it works
Contour plowing Plow across the slope instead of down it, so furrows hold water.
Terracing Build flat steps on hills so water cannot run straight down.
Cover crops Plant crops in the off-season so roots and leaves protect the ground.
No-till or reduced tillage Leave the old stubble and avoid turning the soil over, keeping structure.
Windbreaks Rows of trees slow wind and reduce wind erosion.
Crop rotation Alternating crops, including nitrogen-fixing legumes, keeps nutrients balanced.
Buffer strips Grass or trees beside streams trap sediment before it reaches the water.

Other threats are salinization (salts build up in irrigated dry land), compaction, desertification and loss of organic matter. Good management returns organic matter with compost, manure or crop residue.

Python Erosion and slope: a conservation comparison

Press Run (or Ctrl + Enter) to see the result here.

Program input · what you'd type while the program runs

Type the answers before you press Run, one per line. Each time the program reads a line (with input()), it gets the next line from this box.

Check your understanding

Quick check · 4 questions

of 4 answered You scored / 4 · perfect!

  1. 1. Which soil texture is generally best for growing plants?

    Loam balances sand, silt and clay, so it drains well and still holds water and nutrients.
  2. 2. A soil has bulk density 1.325 g/cm³ and particle density 2.65 g/cm³. What is its porosity?

    Porosity = 1 − 1.325/2.65 = 1 − 0.5 = 0.5, or 50%.
  3. 3. How many times more hydrogen ions does a soil at pH 4 have than one at pH 6?

    Each pH unit is a factor of 10, so two units is 10 × 10 = 100.
  4. 4. Which practice builds flat steps on a hillside to slow runoff?

    Terraces turn a long slope into short level steps so water cannot gain speed.

Summary

  • Texture (sand, silt, clay), structure and porosity decide how soil handles water and air.
  • Porosity = 1 − bulk density / particle density; compaction lowers it.
  • pH is logarithmic; most crops like about 6 to 7.5.
  • Bare, sloping, loose soil erodes fastest, and topsoil is lost first.
  • Contour plowing, terraces, cover crops, no-till and windbreaks reduce erosion.

Next: The Water Cycle