Skip to content
Tutorials Center
My learning

Topics

Lesson 14 of 38 Β· Physical Geography

Coasts and Glaciers

Learn how waves shape cliffs, arches, beaches and spits, how glaciers carve U-shaped valleys and fjords, and how ice affects sea level.

Two forces that can reshape land are very different in speed and style: waves, which batter coasts every day, and glaciers, which creep for centuries. Both erode rock, carry sediment and deposit it, following the pattern you met in weathering, erosion and deposition. This lesson shows the landforms each one makes.

Waves and the coast

Waves are made by wind blowing over the sea. Their size depends on the wind speed, how long it blows, and the fetch, the distance of open water it blows across. As a wave reaches shallow water it slows, grows taller and breaks.

  • A constructive wave is low and gentle, with a strong swash (water running up the beach) and a weak backwash (water running back). It builds beaches.
  • A destructive wave is high and steep, with a weak swash and a strong backwash. It removes material and erodes the coast.

Waves erode in four ways: hydraulic action (air and water forced into cracks), abrasion (waves hurling pebbles), attrition (carried stones getting smaller and rounder) and solution (dissolving of rock such as limestone).

Erosional landforms

Where waves attack a coast of mixed hard and soft rock, a chain of landforms develops:

  1. Waves undercut the base of a cliff, forming a wave-cut notch.
  2. The overhang falls, and the cliff retreats, leaving a flat wave-cut platform.
  3. A crack in a headland is enlarged into a cave.
  4. A cave that is cut right through becomes an arch.
  5. When the arch roof collapses, a stack (isolated pillar) remains.
  6. The stack wears down to a stump.
flowchart LR
    A["Crack in headland"] --> B["Cave"]
    B --> C["Arch"]
    C --> D["Stack"]
    D --> E["Stump"]

Stages in the erosion of a headland.

Headlands and bays form where bands of hard and soft rock meet the sea: the soft rock erodes into a bay and the hard rock is left sticking out.

Depositional landforms

  • Beaches are accumulations of sand or pebbles between low and high tide marks.
  • Longshore drift moves sediment along a beach: waves arrive at an angle (swash goes up diagonally) but backwash falls straight down the slope, so material zigzags along the coast.
  • A spit is a long finger of sand or shingle attached at one end to the land, formed where the coast changes direction and longshore drift continues straight on. A bar closes a bay completely.

Coastal erosion stages

Cave
Arch
Stack
Stump
1 / 2

Glaciers and ice

A glacier is a large, long-lived mass of ice that moves slowly downhill under its own weight. Glaciers form where more snow falls than melts in a year. Snow gets buried and compressed into ice. Today glaciers and ice sheets cover roughly 10 percent of the land surface. The two great ice sheets are in Antarctica and Greenland, and they hold most of the world's fresh water.

During the cold periods of the Pleistocene epoch (often called the Ice Ages), ice covered much more of Europe and North America than it does now. Many of the landscapes of northern countries were shaped then.

How glaciers erode

  • Plucking: meltwater freezes onto rock; when the glacier moves it pulls pieces away.
  • Abrasion: rock fragments frozen into the ice scrape the valley floor and sides like sandpaper, leaving scratches called striations.

Erosional landforms

Landform What it is
Cirque (corrie or cwm) An armchair-shaped hollow high on a mountain where a glacier starts; often holds a small lake (tarn)
ArΓͺte A knife-edge ridge between two cirques
Pyramidal peak A sharp mountain top with cirques on several sides (like the Matterhorn)
U-shaped valley A wide, flat-floored valley with steep sides, cut by a glacier
Hanging valley A side valley left high above the main valley floor, often with a waterfall
Fjord A long, deep, narrow sea inlet formed when a U-shaped valley floods (Norway, Chile, New Zealand)

Depositional landforms

A glacier carries rocks and clay called till (or boulder clay). When it melts, it leaves them behind as moraines (ridges of till), drumlins (smooth oval hills) and erratics (large boulders left far from their source rock).

Glaciers are retreating in most regions as the climate warms, and the meltwater adds to sea-level rise. Melting ice that is already floating, such as sea ice, does not raise sea level much. The ice sheets on land do.

Wave energy and fetch

Wave height depends on wind and fetch. The first program uses a very rough teaching rule (not an accurate forecasting formula) to compare how much energy different seas can build up: more fetch and stronger wind produce bigger waves.

JS Fetch and wave size (teaching model)

Press Run (or Ctrl + Enter) to see the console output here.

No output.

Glacier mass balance

A glacier grows if accumulation (snowfall) exceeds ablation (melting and loss). The balance of the two over a year is its mass balance. This program tracks a made-up glacier over ten years. It simply adds up numbers, to show how repeated small losses shrink a glacier.

JS Mass balance of a glacier

Press Run (or Ctrl + Enter) to see the console output here.

No output.

Check your understanding

Quick check Β· 4 questions

of 4 answered You scored / 4 Β· perfect!

  1. 1. What is the correct order of coastal erosional landforms from a headland?

    A crack widens to a cave, then an arch, then the roof collapses leaving a stack, which wears down to a stump.
  2. 2. What moves sediment along a beach in a zigzag path?

    Waves hit the beach at an angle, but backwash returns straight down the slope.
  3. 3. A fjord is best described as:

    Fjords are deep inlets formed when a glacier-carved U-shaped valley is flooded by the sea.
  4. 4. Which pair shows a glacial erosional landform and a depositional landform?

    A cirque is carved by erosion, while a moraine is deposited till.

Summary

  • Constructive waves build beaches; destructive waves erode coasts.
  • Coastal erosion makes caves, arches, stacks and wave-cut platforms; deposition makes beaches, spits and bars.
  • Longshore drift moves sediment along the coast.
  • Glaciers erode by plucking and abrasion, creating cirques, arΓͺtes, U-shaped valleys and fjords, and deposit moraines and drumlins.
  • Melting land ice raises sea level and many glaciers are shrinking.

Next: Weather, Climate and What Controls Them